DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio - SHCA

DC Audio 10.0k - 10,000w Monoblock Amplifier

$2,639.99
/
  • Free shipping*

The 10.0kw competition series amplifier is a 10,000 watt mono block. It is built for 12 volt audio systems.

It will not operate on 16 or 18 volt systems. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped for 20,000 watts of power. It comes with a bass knob and a clipping indicator.
For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.

Key Features

• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Triple 0 awg power and ground inputs

We recommend for installation
• 1 upgraded battery under the hood
• 3 extra 800ci battery in the rear
• Minimum of two 0 awg ran from the front battery to the rear batterys
• All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp
• 2 upgraded aftermarket alternators
• Dash mounted voltage meter

  Features Voltage 10.0kw
Output Power (RMS) 4 ohm 14.4V 3,000W x 1
2 ohm 5,500W x 1
1 ohm 10,000W x 1
1 ohm 16V N/A
1 ohm 18V N/A
Input Sensitivity     6V~0.2V
Low Pass Filter Switchable    
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable    
( @ 24dB slope ) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response   Hz 15-270
Signal to Noise Ratio   dB 100
Damping factor     150<
Efficiency @ 4ohm   % Over 90%
THD @ 4ohms     Less than 0.1%
Fuse Rating     1,000 Amps
Linked Fuse Rating     2,000 Amps
Indicator Power   Yes
Protection   Yes
Clip   Yes
Speaker & Power terminal Mold Type    Yes
Power Gauge 0Ga x 3
Heatsink Length     37
Heatsink Width inch/mm   11.5
Heatsink Height     2.6

As soon as your item is ready to ship you will receive an email with tracking information. We use FedEx, UPS and YRC Freight for all shipments.

*Shipping is free in the lower 48 states, unless otherwise stated.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

You may also like

Innovative

Gately Acrylic

We are dedicated to building unique and beautiful enclosures that sound as good as they look.